German-engineered · externally mounted
The thruster that bolts on
without cutting a tunnel.
Yacht Thruster™ mounts to the outside of the hull — one 50 mm hole, no fiberglass work, no haul-and-rebuild. Bow or stern, power or sail, 20 to 70 ft.
Why owners choose it
Built to install fast and run long.
Easy installation
Drill three small holes, seal with the supplied gasket and bolts, done. No fiberglass work, no tunnel.
Long runtime
Water-cooled by its external placement, so you get far longer run cycles and low battery draw versus traditional thrusters.
Minimal noise
Mounting the drive outside the hull cuts roughly 80% of the noise and kills hull-cavitation rumble.
Space saving
The whole drive unit lives outside the boat. Only the wiring, control box and power supply stay inside.
Higher efficiency
A short transverse channel and leverage off the pivot point deliver up to 40% more efficiency than conventional systems.
No drag penalty
The hydrodynamic shape adds almost no water resistance — no perceptible loss of speed under power or sail.
Milled from solid blocks of hi-tensile aluminum. A hand-built, fully sealed motor with rare-earth magnets. The original external thruster, on thousands of boats worldwide.
See if it fits your boatFree, no obligation
Tell us about your boat.
Send a few details and our team will recommend the right model and walk you through installation. Most boats 20–70 ft are a fit.
- Model matched to your hull and length
- Straight answers on install and pricing
- Talk to people who build the product
Prefer to talk? 888-898-8608